Miller XT60 Manuel - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Miller XT60. Miller XT60 40 pages.

Imprimer la page

1. Section 7 − Parts List

3-1. XT30 Specifications

Torch −

The XT30 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum

375X-TREME. Do not use this torch in combination with any other machines.

Gas Type

Gas Quality

Gas Inlet Flow and Pressure

Gas Filtering

Cooling Method

Duty Cycle of Torch

Rating of Electrical Controls (Trigger)

Rating of Electrical Controls (Cup)

Approved Systems

Trigger Protection

Safety Devices

Rated Capacity (edge start)

Sever Cut Capacity (edge start)

Pierce Capacity

*Travel speeds are approximately 80% of maximum.

Weight

Requirements for the torch connection

Use only compressed air which is free from dirt, oil, and water.

Ensure that the connections are properly assigned and tightened.

For torch replacement, see Miller torch manual Part No. OM-1593

Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.

3-2. XT30 Torch Dimensions

OM-254 449 Page 10

SECTION 3 − SPECIFICATIONS

Spectrum 375 X-TREME w/XT30

3/8 in. at 18 ipm (457 mm/min)*

1-3/16 in.

(30 mm)

Air or Nitrogen

Clean, moisture−free,

oil−free

5.0 SCFM (142 L/min)

Particulates to 5 microns

Air

100% at 30 Amps

30 VDC at .1 Amps

30 VDC at 1 Amp

torch

Safety trigger guard

Safety interlock devices shut

down power source

5/8 in.

3/16 in.

2.3 lb (1 kg)

8-3/4 in.

(222 mm)

1-1/2 in.

(38 mm)

−−

90 PSI (621 kPa)

120 PSI (827 kPa)

Min

Max

−−

− −

−−

− −

Ref. 253 554-A