ABB E-Hub 2.0 Pour commencer - Page 9

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} ABB E-Hub 2.0. ABB E-Hub 2.0 18 pages.

P R O V I S I O N I N G S T E P S

E-Hub 2.0 Communication – To Internet – Wi-Fi

Follow the next instructions if you want to

connect the E-Hub 2.0 to internet through the

Wi-Fi network. Be sure that the E-Hub 2.0 ETH0

port is not connected to any network via an

ethernet cable.

Click the "Connectivity" tab then select "To

Internet" and click on the "Wi-Fi" tile.

Click on "Start Scan" and wait until your Wi-Fi

network is discovered, then click on it and fill in all

the parameters in the "SELECTED NETWORK" box

and then click "Connect". Device will reboot.

If needed you can edit the TCP/IP parameters

according to the Wi-Fi network, for example you

can force a static IP address.

E-Hub 2.0 Communication – To Internet – Cellular

Follow the next instructions if you want to

connect the E-Hub 2.0 to internet through the

Cellular (3G/4G) network. Be sure that the E-Hub

2.0 ETH0 port is not connected to any network via

an ethernet cable.

Click the "Connectivity" tab then select "To

Internet" and click on the "Cellular (3G/4G)" tile.

Fill in all the parameters in the "CELLULAR" box

and then click "Connect". Device will reboot.

E-Hub 2.0 Communication – To devices

Follow the next instructions to configure the

connectivity to field devices.

Click the "Connectivity" tab then select "To

devices". In the boxes "RS-485 COM 0" and "RS-

485 COM 1" you can configure the connectivity

with Modbus 485 devices. In the box "ETH1" you

can configure the parameters according to the

network where ETH1 port is connected, for

example you can force a static IP address and

disable/enable the DHCP server.