Aquatic BLUECUBE+ AQ-BC-6UBT-X Manuel d'utilisation et d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Aquatic BLUECUBE+ AQ-BC-6UBT-X. Aquatic BLUECUBE+ AQ-BC-6UBT-X 18 pages. 'hide-away' media player

Imprimer la page

Getting Started

1.9 Handheld Remote Control Charging

The remote has a built-in Polymer Lithium rechargeable battery and comes with a charg-

ing cable. Connect one end of the charging cable to the charging connection on the remote

control and connect the USB end of the charging cable to any USB charger (5V DC) for

charging.

Make sure the remote has been charged before used.

1.10 Handheld Remote Control Synchronizing

The remote should already be paired from the factory, but if you need to synchronize the

remote, follow the steps below.

1. Make sure BlueCube+ Media Player is powered ON (red LED)

2. Put the remote within 0.5 meter of the BlueCube+ Media Player.

3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress".

Release the button.

4. Within 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show "Retry

again". If this happens, wait 5 seconds and repeat steps above.

For any additional remote controls, you will also need to synchronize those remote controls to

the BlueCube+ Media Player.

If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote

control if the battery is low.

Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD

shows nothing, the battery has been drained and will need charging.

If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the

new remote control.

www.aquaticav.com

BlueCube+ Media Player AQ-BC-6UBT-X