Aquatic AD504 Manuel du propriétaire et d'installation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et d'installation pour {nom_de_la_catégorie} Aquatic AD504. Aquatic AD504 18 pages. 4/3/2 channel amplifier
Imprimer la page
3 Channel/Bridge Mode
3 Channel/Bridge Mode operation allows you to connect this amplifier to one
pair of main speakers on channels 1 & 2, plus a subwoofer on output channels
3 & 4. The main speakers will operate in STEREO while the subwoofer simulta-
neously operates in MONO.
To set the amplifier to run in this mode, put the crossover switch in the FULL
position.
6.1 Power & Speaker Wiring
GREEN/
BLACK
NOTE: Green, black and purple wires will not be connected.
WARNING: Always insulate the wire when not in use. Otherwise, it can cause a
!
short circuit. Also do not use the speaker wires or RCA cable near power wires to
avoid interference.
www.aquaticav.com
SPEAKER
IMPEDANCE
4 OHMS
GREY
CH 1
Speaker
GREY/BLACK
CH 2
Speaker
WHITE
SPEAKER
WHITE / BLACK
IMPEDANCE
4 OHMS
GREEN
PURPLE
PURPLE / BLACK
SPEAKER
IMPEDANCE
4 OHMS
AD500.4 - 4/3/2 CHANNEL AMPLIFIER
POWER
1
GND 8 AWG BLACK
2
+12V 8 AWG RED
3
TRIGGER 16 AWG BLUE
SPEAKER OUTPUT
4
FRONT RIGHT (NEG)16 AWG GREY/BLACK
5
FRONT RIGHT (POS)16 AWG GREY
6
FRONT LEFT (POS)16 AWG WHITE
7
FRONT LEFT(NEG) 16AWG WHITE/BLACK
8
REAR RIGHT(NEG) 16AWG PURPLE/BLACK
9
REAR RIGHT(POS) 16AWG PURPLE
10
REAR LEFT(POS) 16AWG GREEN
11
REAR LEFT(NEG) 16AWG GREEN/BLACK
11