Aquatic Access IGAT-180/135 Manuel d'installation - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aquatic Access IGAT-180/135. Aquatic Access IGAT-180/135 18 pages.

Imprimer la page

TROUBLESHOOTING

Symptom

Seat bounces on descent

Air in Cylinder Every Day

Lift rises slower than normal

Waters squirts from top of

cylinder

White, gray or brown chalky

deposit.

Corrosion of Metal Parts

Water leakage from top of valve

Chair doesn't come up all the

way

Electrolysis

REMINDER

Be sure to mail your unit's warranty card back to Aquatic Access Inc., 417 Dorsey Way,

Louisville, KY 40223-2388. Please make a note of your lift's serial number below and store these

instructions in a safe place for future reference.

Model ________________________ Serial Number _____________________________

Date of Purchase________________ Purchased from____________________________

Cause

Air in the cylinder

Air entering hose or cylinder if

seat is left in the down position

and the water is shut off.

Low Water Pressure

(Heavier than usual swimmer on

lift; defective hose, dirt in valve

could also cause)

Lift kept under pressure.

Large amounts of water are

getting past the seal.

High pH, high total alkalinity,

high calcium content (hard)

water

Low pH, Low total alkalinity, low

calcium content (soft) water.

Seal around valve stem

defective

Deposits or dirt in valve,

malfunction of valve

Improper grounding of unit

Remedy

Purge air out by running the

lift up and down two or three

times. See operating label.

Purge air out by running the

lift up and down two or three

times. See operating label

None. Fluctuations in city water

pressure are not unusual.

(Replace defective part or clean

valve)

Turn off water each night.

Often this corrects itself. If not,

then clean or replace the seal.

Clean unit with soft cloth or

Scotchbrite® pad, apply car wax

to protect finish.

Clean unit with soft cloth or

Scotchbrite® pad, was with car

wax to protect finish.

Replace defective part.

Clean or replace valve.

Add a ground to unit.