HTC 420 VS Manuel de l'utilisateur - Page 40

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HTC 420 VS. HTC 420 VS 46 pages. Floor grinder | concrete floor sander
Également pour HTC 420 VS : Manuel (50 pages)

Imprimer la page
Electronic Error Codes
2.
3.
4.
Tip!
The machine will not start if the Grinding knob is in the "FWD"
mode when switching on the power.

7.3.2. Checking the last error code

For the buttons and knobs described here, see Figure
7-1 on page 32.
1.
2.
3.
4.
5.
6.
7.
32
Wait until the display switches off.
Reset the emergency stop switch.
Start the machine by turning the Power knob to "I".
Press Enter. rEF is shown in the display.
Turn the knob counter-clockwise, until non is shown in the
display.
Press Enter. rFr is shown in the display.
Turn the knob counter-clockwise, until nA1 is shown in the
display.
Press Enter. LIS1 is shown in the display.
Turn the knob counter-clockwise, until dP1 is shown in the
display.
Press Enter. The last error code is shown in the display.
Figure 7-1 Enter button and knob - Schneider
HTC 420 VS
3.0