ARCCAPTAIN ARC200 Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ARCCAPTAIN ARC200. ARCCAPTAIN ARC200 15 pages. Inverter welding machine
Press the key combination to display the code table
Digital tube display code
-0/ -1
-0/ -1
5. INSTALLATION AND OPERATION
Note: Please install the machine strictly according to the following steps.
Turn off the power supply switch before any electric connection operation.
The housing protection grade of this machine is IP21S, so do not use it in rain.
5.1 Installation:
1)
A primary power supply cable is available for this welding machine. Connect the primary power
supply cable to the corresponding voltage class based on rated input power of the welder.
Misconnection should be avoided.
2)
The primary cable should be tightly connected to the corresponding power binding post or socket
to avoid oxidization.
3)
Check whether the input voltage value varies in acceptable range with a multi-meter.
4)
Insert the cable plug with electrode holder into the "+" socket on the front panel of the welding
machine, and tighten it clockwise.
5)
Insert the cable plug with ground clamp into the " - " socket on the front panel of the welding
machine, and tighten it clockwise.
6)
Connect the power ground well.
The connection as mentioned above in 4) and 5) is DCRP connection. Operator can choose DCSP
connection according to workpiece and electrode application requirement. Generally, DCRP connection
is recommended for basic electrode (electrode is connected to positive pole), while there is no special
requirement for acid electrode.
-0:Represents no VRD; -1:Representative has VRD
-0:Represents no anti-stick; -1:Representative has anti-stick
Pic 6 Schematic Diagram of MMA Welding
8
Code meaning