ABB REM615 ANSI Manuel d'application - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'application pour {nom_de_la_catégorie} ABB REM615 ANSI. ABB REM615 ANSI 20 pages. Motor protection and control

ABB REM615 ANSI Manuel d'application
Section 1
Introduction
1.4.2
1.4.3
8

Document conventions

A particular convention may not be used in this manual.
Abbreviations and acronyms in this manual are spelled out in the glossary. The
glossary also contains definitions of important terms.
Push-button navigation in the LHMI menu structure is presented by using the
push-button icons.
To navigate between the options, use
HMI menu paths are presented in bold.
Select Main menu/Settings.
LHMI messages are shown in Courier font.
To save the changes in non-volatile memory, select Yes and press
Parameter names are shown in italics.
The function can be enabled and disabled with the Operation setting.
Parameter values are indicated with quotation marks.
The corresponding parameter values are "On" and "Off".
IED input/output messages and monitored data names are shown in Courier font.
When the function starts, the START output is set to TRUE.

Functions, codes and symbols

Table 1:
REM615 functions, codes and symbols
Function
Protection
Three-phase non-directional overcurrent
protection, low stage
Three-phase non-directional overcurrent
protection, instantaneous stage
Non-directional earth-fault protection, low stage
Non-directional earth-fault protection, high stage
Directional earth-fault protection, low stage
Three-phase undervoltage protection
Positive-sequence undervoltage protection
Negative-sequence overvoltage protection
Frequency protection
Negative-sequence overcurrent protection for
motors
Loss of load supervision
Motor load jam protection
Motor start-up supervision
Phase reversal protection
Table continues on next page
and
.
IEC 61850
IEC 60617
PHLPTOC1
3I> (1)
PHIPTOC1
3I>>> (1)
EFLPTOC1
Io> (1)
EFHPTOC1
Io>> (1)
DEFLPDEF1
Io> -> (1)
PHPTUV1
3U< (1)
PSPTUV1
U1< (1)
NSPTOV1
U2> (1)
FRPFRQ1
f>/f<,df/dt (1)
FRPFRQ2
f>/f<,df/dt (2)
MNSPTOC1
I2>M (1)
MNSPTOC2
I2>M (2)
LOFLPTUC1
3I<
JAMPTOC1
Ist>
STTPMSU1
Is2t n<
PREVPTOC1
I2>>
1YHT530017D05 B
.
IEC-ANSI
51P-1 (1)
50P/51P (1)
51N-1 (1)
51N-2 (1)
67N-1 (1)
27 (1)
47U+ (1)
47O- (1)
81 (1)
81 (2)
46M (1)
46M (2)
37
51LR
49,66,48,51LR
46R
REM615
Application Manual