Ayra 9000-0021-6269 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ayra 9000-0021-6269. Ayra 9000-0021-6269 13 pages. Rgbawp led light effect
Imprimer la page
To activate the unit, connect the power cable with a suitable power outlet. The unit will activate directly after it
is plugged in to a wall outlet or other power source.
The status of the fixture is shown on the display. Certain values determine the current status and will change
when you push buttons on the control panel. The buttons each have their own function, for easy navigation in
the control panel.
Display codes:
display
Mode
A001
DMX address setting
SLAV
Master/Slave mode
A...
Auto mode
S1 / S2
Sound-actived mode
Operating modes:
DMX mode: The most extensive operating mode, as it allows you to control the system with a standard
DMX-512 controller, using the 3p DMX inputs and outputs. Select the right starting address, and you'll have
full control over the system with your DMX controller.
Auto mode: Select one of the internal programs, which will activate and run in a continuous loop. Users can
set the desired speed; a low value means low speed and fluent movement, while a high value induces high
speed.
Master/slave mode (sync mode): Connect two or more TDC Sunrise devices with a standard 3p male to 3p
female XLR cable. (Not included in delivery.) The first system will act as a master fixture, the second system
will mimic the actions of the first system, thus creating synchronised effects.
To ensure that this function works properly, connect the DMX OUT connector of the first system to the DMX
IN connector of the second system. Set the second system to Slave mode. Connecting more than a single
slave is possible, with a maximum of 16 units.
Music-controlled mode (sound-activated): Select one of the available music-controlled modes with the
display and menu buttons. In sound-activated mode, the device will respond to the beat of the music thanks
to a built-in microphone.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Setting up the unit
Function
A001-A512
Set to slave mode, the fixture
will respond to another TDC
Sunrise fixture and mimic all
its actions.
A1 = red and yellow is on
A2 = green and white is on
A3 = blue and pink is on
A4 = colour mixing and colour
jump change 1
A5 = colour mixing and colour
jump change 2
A6 = fade change
A7 = strobe colour fade
Select sound-actived mode 1
or 2.
Then select motor speed 0-
20, with 0 being very slow and
20 very fast.
Creation date + author initials: 28-10-2015 RV Revision date + author initials: -
Description
Set the DMX start address by
choosing a value between 1 and
512.
NOTE: only possible if you connect
two TDC Sunrise units with a 3p XLR
cable.
Set the unit to Slave, and the slave
device will mimic the actions of the
first device.
Set the automatic mode by choosing
between the several available auto
modes. Enter a mode and select a
speed between 1 and 9, which
changes the motor rotation speed.
Sound-actived mode 1: motor and
colour respond to the beat.
Sound-actived mode 2: motor
responds to the beat.