Ayra Ita04 MKII Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ayra Ita04 MKII. Ayra Ita04 MKII 10 pages.

Setting up the device

- When the power supply is connected, the unit will first calibrate the stepping motors of the unit. It is

normal that this may cause any noise. When the calibration is done, the unit is ready to be used (in the

selected DMX, automatic or music controlled mode)

- It is possible that the unit may shut off the beam projection when no music or sound is detected. This

will avoid the projection of a solid, static beam, which may cause injury to eyesight.

- This unit uses stepping motors to create variable movements to the laser beam. This way, figures

and patterns can be made. The unit uses high-speed stepping motors to create the moving beams of

the laser. It is normal that the laser beam and projection may appear 'flickering' when projecting large

or complex patterns.

- The projected beams of the unit may appear shivering when projecting complex or large patterns on

surfaces as a wall, ceiling or decorative cloth.

Selecting a working mode

This laser device has three working modes, which are automatic, music-controlled and DMX. To

select the right operating mode for your situation, use the dipswitch panel on the rear of the unit.

A DMX-dipswitch panel works with a binary character. It sends a 0 or 1 message to the electrical

circuit. To select a working mode, pay close attention to the information scheduled below. Every DMX

dipswitch stands for a certain value, which is on or off. The values are stated as below:

1 – 1

2 – 2

3 – 4

4 – 8

5 – 16

6 – 32

7 – 64

8 – 128

9 – 256

10 – mode switch (DMX ON/OFF)

To select the different working modes, pay close attention to the setting of DMX dipswitches below: