Sharp Notevision XG-C455W Manuel de configuration - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Sharp Notevision XG-C455W. Sharp Notevision XG-C455W 45 pages. Wxga (1280x800), 4000 ansi lumens 3-lcd conference/classroom projector
Également pour Sharp Notevision XG-C455W : Spécifications (2 pages)
Imprimer la page
1. Connecting the Pro-
jector to a Computer
Establishing a one-to-one connection from the
projector to a computer. Using a commercially
available LAN cable (UTP cable, Category 5,
cross-over type) you can configure the pro-
jector via the computer.
1
Disconnect the computer's LAN
cable from the existing network.
2
Connect a commercially avail-
able LAN cable (UTP cable, Cat-
egory 5, cross-over type) to the
projector's LAN terminal and
connect the other end of the
cable to the computer's LAN
terminal.
3
Plug the power cord into the AC
socket of the projector.
4
Turn on the computer.
Info
Confirm that the LINK LED on the rear of the
projector illuminates. If the LINK LED does not
illuminate, check the following :
• The LAN cable is properly connected.
• The power switches of both the projector
and the computer are on.
This completes the connection. Now proceed to "2. Setting an IP Address for the Com-
puter".
Setting up the Projector Network Environment
A LAN cable being
connected to the network
(cross-over type, commercially available)
LAN cable
ON
-19