Ricoh Pro C900s Manuel d'installation - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Ricoh Pro C900s. Ricoh Pro C900s 24 pages. Color server options
Également pour Ricoh Pro C900s : Spécifications (6 pages), Caractéristiques Manuel (27 pages), Brochure & Specs (8 pages), Notes à l'attention des utilisateurs (2 pages), Addendum de l'utilisateur (24 pages), Manuel d'information sur la sécurité (12 pages)

Imprimer la page
Ricoh Pro C900s Manuel d'installation
□
Ring Binder (RB5000)
□
Stacker (SK5000)
□
3000 sheet finisher (SR5000).
□
Plockmatic
□
Perform the peripheral skew and side to side adjustment:
□
Print two copies of final version full SMC reports and Fiery
Configuration Pages.
Colour High Volume Production System - Installation Guide
Pro C900
a. Print a single page punch only output and check the
location of the punched holes. Refer to the Ring Binder
service manual for full details. Adjust using SP6-504 if
required.
b. Print a ring bound booklet to the maximum allowable
thickness, using each one of the ring binder cartridges
purchased. Ensure that each binding comb is closing
correctly.
□
1.
GBC Stream Punch III
a. Follow the Ricoh GBC Stream Punch III Installation and
Set–up document that is supplied with the GBC Stream
Punch III and also available at
http://partners.ricoh.com.au/web/aubase/technical/docum
ents.nsf/allbymodel/C74C98B6BE92DE89CA2572F000175C
AB?OpenDocument
b. Punch 50 sheets from each one of the die sets and confirm
all punch holes are positioned correctly and that the die
sets are perforating the media fully.
a. If required, the Lead Edge and Side to Side Jogger
position can be adjusted. Please refer to the Pro C900 /
Pro C00s and the Stacker Service Manuals for full details.
a. If a punch unit is installed print a 5-page punched
document.
b. Check the position of the punch holes. If the punch holes
are not correctly positioned in the front to rear position,
install spacers (to the rear of the SR5000) provided with
the punch unit. See the SR5000 Service Manual for
details.
c. If the punch holes are not positioned correctly in the left
to right direction, adjust SP6-101.
d. Print a 20-page document with corner staple. If the sides
of the stack do not appear aligned, adjust SP6-102.
a. Follow the service manual for the BK5010e system checks.
Available at
http://partners.ricoh.com.au/
a. The paper feed path can be very long. The cumulative
effect of such a long path can result in paper skewing and
deviating in the side to side direction at the paper exit.
Page 21 of 24