Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manuel de démarrage rapide - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 pages. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas

Imprimer la page

Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manuel de démarrage rapide

Installation and Configuration

Figure 8

Note

Be sure the cables are routed away from the AP antennas.

When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and

Note

Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP begins broadcasting its beacon

signal(s). When this happens, complete the installation as quickly as possible to remove yourself from

within 8 inches (20 cm) of the AP to comply with FCC RF radiation exposure guidelines.

You have installed the AP. Repeat

with

Flush Wall Mount

When you are mounting the AP against a wall (flat side toward the inside of the building), use an optional

separately orderable flush-mount bracket.

Note

The AP threaded holes have precision-depth threads. Do not overtighten the screws, or the bracket will

not fit under the screw heads.

7817146-01

Attaching the AP to the Projection-Mount Bracket

Attach the cables to the sides of the AP.

"Returning MAC

Information".

Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom

of the AP. Be sure the spring washers have their convex (high center sections) pointing toward the

screw heads.

AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal

"Mounting the Access

Points"

Mounting the Access Points

for each AP location, and then continue