ACU-RITE 01141 Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ACU-RITE 01141. ACU-RITE 01141 20 pages. Professional weather center

Imprimer la page

5-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT

(1.5 meters) off the ground, in an open area. Higher is better for wind

measurements - The National Weather Service recommends 33 feet

(10 meters) high!

MOUNTING OPTIONS

directly onto wooden posts or surfaces that are 2 x 4 (4.5 cm x 9.5 cm) or larger.

The sensor can also be mounted directly to common 3/4" (20 mm) steel pipe.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a post

or pole (not included) using the 4 longer

screws included in the hardware bag.

2. Insert the mounting base into the hole on

the bottom of the sensor.

3. Make sure the arrows on the top of the

sensor are pointed in the proper direction

and the bubble level is centered. The

solar cell should be facing south to

properly orient the wind direction.

4. Fasten the sensor into the mounting base

using the 2 shorter screws included in the

hardware bag.

The 5-in-1 sensor is now

ready to use.

Clear Data Collected During Installation

When installation is complete, press and release the "RESET" button, located

on the back of the display inside the battery compartment, to clear erroneous

data from the display.

Basic Setup is Complete

The 5-in-1 sensor will now synchronize with the display. It may take a few

minutes for synchronization to complete. If both or one of the units appear to

be functioning improperly, please refer to the troubleshooting section.

Mount the sensor at a minimum height of 5 feet

The included mounting bracket it designed to screw

NO OBSTRUCTIONS

ABOVE OR AROUND

T H

S O U

(1.5 meters)