ACU-RITE 02033 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ACU-RITE 02033. ACU-RITE 02033 13 pages. Professional weather center

Imprimer la page

Troubleshooting

Problem

• Relocate the display and/or the 5-in-1 sensor.

The units must be within 330 ft (100m) of each other.

• Make sure both units are placed at least 3 ft

(.9 m) away from electronics that may interfere with

the wireless communication (such as TVs, microwaves,

computers, etc).

• Use standard alkaline batteries (or lithium batteries

in sensor when temperature is below -4ºF/-20ºC). Do

No outdoor sensor

not use heavy duty or rechargeable batteries. NOTE:

reception

It may take a few minutes for display and sensor to

synchronize after batteries are replaced.

no bars

• Synchronize the units:

1. Bring both the sensor and display indoors and

remove power adapter/batteries from each.

2. Reinstall batteries in outdoor sensor.

3. Reinstall power adapter/batteries in display.

4. Let the units sit within a couple feet of each other

for a few minutes to gain a strong connection.

Flashing of the outdoor temperature is generally an

indication of wireless interference.

1. Bring both the sensor and display indoors, side by

Outdoor

side and remove power adapter/batteries from

each.

temperature

2. Make sure the A-B-C switch on both units match.

is flashing or

showing dashes

3. Reinstall batteries in outdoor sensor.

4. Reinstall power adapter/batteries in display.

5. Let the units sit within a couple feet of each other

for a few minutes to gain a strong connection.

• Weather Forecast icon predicts conditions for the next

12 to 24 hours, not current conditions.

• Has Learning Mode icon disappeared from the

display? Learning Mode must complete before

forecast and pressure will be accurate.

Inaccurate forecast

• Allow unit to run continuously for 33 days. Battery

removal or resetting the display will restart Learning

Mode. After 14 days, forecast should be fairly

accurate, however Learning Mode calibrates for a

total of 33 days.

Possible Solution

Troubleshooting

Problem

• Make sure both the display and 5-in-1 sensor are

placed away from any heat sources or vents

(see page 10).

Inaccurate

• Make sure both units are positioned away from

temperature or

moisture sources (see page 10).

humidity

• Make sure 5-in-1 sensor is mounted at least 5 ft (1.5

meters) off of the ground.

• Calibrate indoor and outdoor temperature and

humidity (see page 19).

• Check to ensure the rain gauge stabilizer (plastic tab)

has been removed from the bottom of the sensor (see

page 7).

No rainfall

• Clear debris, such as leaves, out of the rain collector

funnel and debris screen.

• Calibrate the Rain Gauge (see page 20).

• What is wind reading being compared to? Pro

weather stations are typically mounted at 30 ft

(10 meters) high or more. Make sure to compare

data using a sensor positioned at the same mounting

height.

Inaccurate wind

• Check location of the sensor. Ensure it's mounted

readings

a minimum of 5 ft (1.5 meters) in the air with no

obstructions around it (within several feet).

• Ensure wind cups are spinning freely. If they hesitate

or stop try lubricating with graphite powder or spray

lubricant.

• Check that the power adapter is plugged into the

display and an electrical outlet.

• Check that the batteries are installed correctly.

Display screen

Batteries may need to be replaced.

not working

• Reset the display by pressing and holding the Reset

button, located in the battery compartment of the

display. Date and time will need to be entered after

a reset.

Possible Solution