Cisco Physical Access 1125 Appliance Manuel de l'utilisateur - Page 38
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco Physical Access 1125 Appliance. Cisco Physical Access 1125 Appliance 42 pages.
Imprimer la page
Connecting to the AC Power Source
Connecting to the AC Power Source
Warning
This equipment must be grounded. Never defeat the ground conductor or
absence of a suitably installed ground conductor.
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Connect the AC power receptacle to the AC power source with the provided power cable.
Connecting Cables
Use unshielded twisted-pair (UTP,) copper-wire Ethernet cable, with standard RJ-45-compatible plugs,
to connect the Cisco PAM to the network.
To connect the cables:
Plug the Ethernet network connection into port ETH 1. See
Step 1
the Ethernet ports.
If a redundant standby appliance is installed, connect the supplied serial cable between the serial ports
Step 2
on each appliance. See
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Next Steps
Configure the Cisco PAM server software as described in the
Guide.
Cisco Physical Access 1125 Appliance User Guide
3-20
Figure 1-3 on page 1-3
for the location of the serial port.
Chapter 3
Rack Mounting the Cisco PAM 1125 Appliance
operate the equipment in the
Contact the appropriate electrical inspection authority
Figure 1-3 on page 1-3
Cisco Physical Access Manager User
for the location of
OL-20929-01