Cisco SCE 1000 and Manuel de démarrage rapide - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco SCE 1000 and. Cisco SCE 1000 and 49 pages. Service control engine 1000 2xgbe
Imprimer la page
Perform the Initial System Configuration
• Initial System Configuration, page 14
• Step 1: Configuring Initial Settings, page 16
• Step 2: Configuring the Hostname, page 17
• Step 3: Setting the Passwords, page 17
• Step 4: Configuring Time Settings, page 18
• Step 5: Configuring the DNS Settings, page 20
• Step 6: Configuring the RDR Formatter Destination, page 21
• Step 7: Configuring Access Control Lists (ACLs), page 22
• Step 8: Configuring SNMP, page 26
• Step 9: Configuring the Topology-Dependent Parameters, page 29
• Step 10: Completing and Saving the Configuration, page 31
Initial System Configuration
• Setup Command, page 14
• Setup Command Parameters, page 14
• Example, page 16
Setup Command
Upon initial connection to the local terminal, as described above, the system configuration wizard automatically runs to guide
the user through the entire setup process. The wizard prompts for all necessary parameters, displaying default values, where
applicable. You may accept the default values or define other values.
When the dialog is complete, you may review the new configuration before applying it. The system displays the configuration,
including parameters that were not changed. The system also displays any errors that are detected in the configuration. When
the configuration is satisfactory, you may apply and save the new configuration.
The following table lists all the parameters included in the initial configuration. It is recommended that you obtain values for
any parameters that you will configure at this time before beginning the setup.
For further information regarding any configuration step or specific parameter, refer to the relevant section in the
Note
SCE 2000 and SCE 1000 Software Configuration
Setup Command Parameters
Table 1
Setup Command Parameters
Parameter
IP address
subnet mask
default gateway
hostname
admin password
14
Guide.
Definition
IP address of the SCE 1000.
Subnet mask of the SCE 1000.
Default gateway.
Character string used to identify the SCE 1000. Maximum 20
characters.
Admin level password.
Character string from 4-100 characters beginning with an alpha
character.
Cisco