Cisco UCS B200 M3 Note d'installation et d'entretien - Page 9

Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B200 M3. Cisco UCS B200 M3 36 pages. Blade server
Également pour Cisco UCS B200 M3 : Manuel d'installation (34 pages), Note d'installation et d'entretien (37 pages), Manuel (8 pages), Manuel de mise à jour (21 pages), Note d'installation et d'entretien (28 pages)

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

Installing and Removing a Blade Server Hard Drive

There are up to two front-accessible, hot-swappable, 2.5-inch drives per blade. An LSI SAS 2004 RAID

controller is embedded in the motherboard (it is not separately replaceable), and it supports RAID 0 and

1. You can remove blade server hard drives without removing the blade server from the chassis. All other

component replacements for a blade server requires removing the blade from the chassis. Unused hard

drive bays should always be covered with cover plates (N20-BBLKD) to ensure proper cooling and

ventilation. The chassis is omitted from illustrations here to simplify the drawing.

To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by

Caution

the carrier edges only.

Caution

RAID array migration between a B200 M1 or B200 M2 and a B200 M3 is not supported

Replacing an HDD or SSD with a drive of the same size, model, and manufacturer should not cause any

problems with UCS Manager. If the drive being replaced was part of a RAID array. we recommend using

a newly ordered drive of identical size, model, and manufacturer to replace the failed drive. We

recommend following industry standard practice of using drives of the same capacity when creating

OL-26624-01

Installing and Removing a Blade Server Hard Drive

Cisco UCS B200 M3 Blade Server Installation and Service Note