Cisco Firepower Management Center 1500 Manuel de démarrage - Page 37
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Firepower Management Center 1500. Cisco Firepower Management Center 1500 42 pages. Firepower management center
Imprimer la page
Table 5
LOM Command Syntax (continued)
IPMItool
(Linux/Mac)
-U username
n/a (prompted on
login)
command
Therefore, for IPMItool:
ipmitool -I lanplus -H IP_address -U username command
Or, for ipmiutil:
ipmiutil command -V4 -J3 -N IP_address -U username -P password
Note that the
chassis power off
a full list of LOM commands supported by the Firepower System, see the Configuring Appliance Settings chapter
in the Firepower Management Center Configuration Guide.
Note:
In some power cycle scenarios, the baseboard management controller (BMC) of a Firepower 7050
connected to the network via the management interface could lose the IP address assigned to it by the DHCP
server. Because of this, Cisco recommends you configure the Firepower 7050 BMC with a static IP address.
Alternately, you can disconnect the network cable and reconnect it, or remove and restore power to the device to
force renegotiation of the link.
Before you can restore an appliance using LOM, you must enable LOM for both the appliance and the user who
will perform the restore. Then, use a third-party Intelligent Platform Management Interface (IPMI) utility to access
the appliance. You must also make sure you redirect the appliance's console output to the serial port.
For more information, see the following sections:
Enabling LOM and LOM Users, page 37
Installing an IPMI Utility, page 38
Enabling LOM and LOM Users
Before you can use LOM to restore an appliance, you must enable and configure the feature. You must also
explicitly grant LOM permissions to users who will use the feature.
You configure LOM and LOM users on a per-appliance basis using each appliance's local web interface. That is,
you cannot use the Management Center to configure LOM on a Firepower device. Similarly, because users are
managed independently per appliance, enabling or creating a LOM-enabled user on the Management Center does
not transfer that capability to users on Firepower devices.
LOM users also have the following restrictions:
You must assign the Administrator role to the user.
The user name may have up to 16 alphanumeric characters. Hyphens and longer user names are not
supported for LOM users.
Cisco Firepower Management Center Getting Started Guide
ipmiutil (Windows)
Description
-U username
Specifies the user name of an authorized LOM
account.
-P
For ipmiutil only, specifies the password for an
password
authorized LOM account.
command
The command you want to issue to the appliance.
Note that where you issue the command depends
on the utility:
and
chassis power cycle
Restoring a Firepower Management Center to Factory Defaults
For IPMItool, type the command last.
For ipmiutil, type the command first.
commands are not valid on 70xx Family appliances. For
37