Cisco UCS Invicta C3124SA Manuel d'installation - Page 26
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco UCS Invicta C3124SA. Cisco UCS Invicta C3124SA 40 pages.
Également pour Cisco UCS Invicta C3124SA : Procédure de mise à niveau (16 pages), Procédure de mise à niveau (20 pages)
Imprimer la page
Installing the Cisco UCS Invicta C3124SA Appliance In a Rack
Figure 2-1
1
6
1
Front-right rack post
2
Rear-right rack post
3
Slide-rail assembly
Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail
c.
assemblies are level and at the same height with each other.
Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops
d.
and lock in place.
Insert the Cisco UCS Invicta C3124SA Appliance into the slide rails (see
Step 2
This Cisco UCS Invicta C3124SA Appliance weighs approximately 60 pounds (28 kilograms) when
Caution
fully loaded with components. We recommend that you use a minimum of two people when lifting the
Cisco UCS Invicta C3124SA Appliance. Attempting this procedure alone could result in personal injury
or equipment damage.
Note
Align the inner rails that are attached to the Cisco UCS Invicta C3124SA Appliance sides with the
a.
front ends of the empty slide rails.
Push the Cisco UCS Invicta C3124SA Appliance into the slide rails until it stops at the internal
b.
stops.
Push in the slide rail locking clip (item 2) on each inner rail, and then continue pushing the Cisco
c.
UCS Invicta C3124SA Appliance into the rack until its front flanges latch onto the rack posts.
Cisco UCS Invicta C3124SA Appliance Installation Guide
2-6
Attaching a Slide-Rail Assembly
3
The inner rails are pre-attached to the sides of the Cisco UCS Invicta C3124SA Appliance at the
factory. You can order replacement inner rails if these are damaged or lost (Cisco PID
UCSC-RAIL-2U-I).
Chapter 2
Installing the Cisco UCS Invicta C3124SA Appliance
2
4
4
Length-adjustment bracket
5
Mounting pegs (two on each end of assembly)
6
Locking clips (one on each end of assembly)
Figure
5
6
2-2):
OL-31369-01