Cisco EVM-IPVS-16A Connexion - Page 11

Parcourez en ligne ou téléchargez le pdf Connexion pour {nom_de_la_catégorie} Cisco EVM-IPVS-16A. Cisco EVM-IPVS-16A 15 pages. Analog video gateway network modules

Imprimer la page
Connecting Cisco Analog Video Gateway Network Modules to the Network
Disconnect the terminal block connector cables from the terminal blocks on the EVM-IPVS-16A
Step 3
network module.
Hazardous voltages may be present in the outdoor camera cables under fault conditions. Disconnect
Warning
all cables from the outdoor cameras before servicing this equipment. Statement 376
Disconnect the DB-37 to BNC video breakout cable from the VIDEO connector on the EVM-IPVS-16A
Step 4
network module.
Using a number 1 Phillips or flat-blade screwdriver, loosen the captive mounting screws on the network
Step 5
module faceplate.
To avoid damaging the network module, always handle the network module by the handle or faceplate.
Caution
Do not touch the circuit board.
Step 6
Using the module handle, pull the network module from the router slot. (See
Figure 7
ETHE RNET 0
Align the replacement network module with the guides in the chassis walls or slot divider and slide it
Step 7
gently into the slot. (See
Figure 8
ETHE RNET 0
Using the network module handle, push the EVM-IPVS-16A network module into place until you feel
Step 8
the edge connector seat securely into the connector on the router backplane. The network module
faceplate should contact the chassis rear panel.
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the network
Step 9
module faceplate.
Connect the DB-37 to BNC video breakout cable to the VIDEO connector on the EVM-IPVS-16A
Step 10
network module.
Removing a Network Module
WO
SERIA L
EVM
IPVS- 16A
20
11
3210
1
Figure
8.)
Installing a Network Module
WO
SERIA L
EVM
IPVS- 16A
20
11
3210
1
Connecting Cisco Analog Video Gateway Network Modules to the Network
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
Figure
7.)
11