Cisco IC3000 Manuel d'installation du matériel - Page 25
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco IC3000. Cisco IC3000 37 pages. Industrial compute gateway
Également pour Cisco IC3000 : Documentation sur les produits (12 pages)
Imprimer la page
Connecting the Cisco IC3000
This chapter describes how to connect the Cisco IC3000 to Ethernet devices and a network.
•
Connecting the Cisco IC3000 Industrial Compute Gateway
This chapter describes how to connect the Cisco IC3000 to Ethernet devices and a network. The chapter
contains the following sections:
Preparing to Connect the Cisco IC3000
Before you connect the Cisco IC3000 to the devices, install the IC3000 according to the instructions in
Installing the Cisco IC3000 Industrial Compute Gateway, on page
Caution: If this product will be installed in a hazardous location, read the Getting Started/Product Document
of Compliance included in the package.
WARNING: To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV
circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement
1021
Preventing Damage to the Cisco IC3000
Before installation, observe these general guidelines:
• Proper ESD protection should be observed
• Ensure the device is properly grounded
• Ensure there is proper airflow around the device
Connecting a PC to the Cisco IC3000 For Configuration
There are two methods of connecting to the Cisco IC3000 in case of troubleshooting:
Connect a PC to the console connector of the Cisco IC3000 and launch a console terminal to use the CLI.
Connect the PC to the Cisco IC3000 management sub-network which will then receive an IP address.
Connecting the Cisco IC3000 Industrial Compute Gateway, on page 23
C H A P T E R
Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide
4
17.
23