Acuity Brands Lighting Lithonia Lighting LDN8 SWW Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Acuity Brands Lighting Lithonia Lighting LDN8 SWW. Acuity Brands Lighting Lithonia Lighting LDN8 SWW 15 pages.

Imprimer la page

C) Lay-in Panel T-bar Ceiling Installation (Cont.)

Once the channel bars are in place, close

the cams to hold the position.

Complete necessary splices. Snap the door

onto the junction box.

Squeeze wire torsion springs on the light

engine and insert each leg of the spring

into the slots on the brackets on each side

of the opening in the mounting frame.

When the cams are in the closed position,

a wire tie can be wrapped through the

indicated holes to ensure the cam stays

closed.

Align the opening in the trim with the tabs

on the light engine. Rotate the trim

clockwise until trim slot aligns with the

hole in the trim holder.

Ensure wire torsion springs are installed as

shown to secure the fixture. Make certain

the wire loops are oriented as shown.

Lithonia Lighting

1400 Lester Road Conyers Georgia 30012

P 800 315 4935 F 770 860 3129

Technical Support P 800-705-7378

www.Lithonia.com

Remove knockouts on junction box to feed

power supply to fixture. Supply wire must

meet applicable electrical codes and be

rated for a minimum of 90°C.

Locking Screw

Once the trim is rotated into place, insert

and tighten the locking screw provided.

912-00206-001 Rev. A

Page 4