Motorola GP320 Series Informations sur les services - Page 15

Parcourez en ligne ou téléchargez le pdf Informations sur les services pour {nom_de_la_catégorie} Motorola GP320 Series. Motorola GP320 Series 30 pages. Professional radio, power distribution and controller
Également pour Motorola GP320 Series : Manuel de l'utilisateur (26 pages), Manuel de l'utilisateur (26 pages), Informations sur les services (32 pages), Informations sur les services (30 pages)

VHF Receiver

3.3

Automatic Gain Control (AGC)

(Refer to the Receiver Front End and Receiver Back End schematic diagrams)

The front end automatic gain control circuit provides automatic reduction of gain of the front end RF

amplifier via feedback. This prevents overloading of backend circuits and is achieved by drawing

some of the output power from the RF amplifier output. At high radio frequencies, capacitor C3327

provides the low impedance path to ground for this purpose. CR3302 is a pin diode used for

switching the path on or off. A certain amount of forward biasing current is needed to turn the pin

diode on. Transistor Q3301 provides this current.

Radio signal strength indicator, RSSI, a voltage signal, is used to drive Q3301 to saturation i.e.

turned on. RSSI is produced by U3220 and is proportional to the gain of the RF amplifier and the

input power to the radio.

Resistors R3304 and R3305 are voltage dividers designed to turn on Q3301 at certain RSSI levels.

To turn on Q3301 the voltage across R3305 must be greater or equal to the voltage across R3324 +

Vbe. Capacitor C3209 is used to dampen any instability while the AGC is turning on. The current

flowing into the collector of Q3301, a high current gain NPN transistor, is drawn through the pin

diode to turn it on. Maximum current flowing through the pin is limited by resistors R3316, R3313,

R3306 and R3324. Feedback capacitor C3326 used to provide some stability to this high gain stage.

An additional gain control circuit is formed by Q3201 and associated components. Resistors R3206

and R3207 are voltage dividers designed to turn on Q3201 at a significantly higher RSSI level than

the level required to turn on pin diode control transistor Q3301. In order to turn on Q3201 the voltage

across R3207 must be greater or equal to the voltage across R3208 + Vbe. As current starts flowing

into the collector of Q3201, it reduces the bias voltage at the base of IF amplifier transistor Q3200

and in turn, the gain of the IF amplifier. The gain is then controlled in a range of -30dB up to +10dB.

2-5