Motorola T3 Manuel de l'utilisateur - Page 27

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Motorola T3. Motorola T3 50 pages. User guide
Également pour Motorola T3 : Manuel de démarrage rapide (2 pages), Brochure (2 pages), Manuel (38 pages)

Imprimer la page
Motorola T3 Manuel de l'utilisateur
Managing the Wireless WallPlates
I
P
A
d
d
r
e
s
s
e
s
I
P
A
d
d
r
e
s
s
e
s
Private IP address
The T3 system requires an IP address for network management. This T3 management address is assigned using
the following command:
ip config ip-address <your IP> mask <your mask> gateway <your gateway>
The Wireless WallPlates also require an IP address for management by the T3 system. The IP address pool
assigned to the Wireless WallPlates can be in the same subnet as the network management IP address, or it can
be a private IP address space that is not used outside the T3 system.
The default configuration is to use a private IP address space to manage the Wireless WallPlates.
Note these important operational parameters when using the private IP space to manage Wireless WallPlates:
1. All T3 systems on the same property (same layer 2 network) can use the same private IP space to
communicate with their own Wireless WallPlates. There will not be an IP conflict on the network.
2. The Wireless WallPlates will not send ARPs to the upstream Ethernet network.
3. The Wireless WallPlates will not send DHCP requests to the upstream Ethernet network.
4. The default private IP address space is 192.168.10.226 through 192.168.10.250. All WallPlates will be
assigned an IP address starting with 192.168.10.226.
5. The default private IP internal address is 192.168.10.1. Use this address when loading new firmware to
the Wireless WallPlate from the internal file system on the T3 Switch.
To enable the private IP addressing, type:
ip private enable
If you desire to set your own private ip addressing space, you must configure two commands:
Enable the private IP gateway:
Configure the private IP network:
For example:
NOTE: The DHCP server will not disable if any WallPlates already have an IP address. It is best to change the
DHCP server config before the WallPlates link, or else you must disable the DSL ports and re-enable them after
the configuration is complete.
To disable all DSL ports and remove DHCP address:
Motorola, Inc.
ip private config <ip> mask <mask>
ip private enable
dhcp server disable
dhcp server config network private start <ip> end <ip>
dhcp server enable
ip private config 1.2.3.4 mask 255.255.255.0
ip private enable
dhcp server disable
dhcp server config network private start 1.2.3.101 end 1.2.3.125
dhcp server enable
interface dsl disable port(1-25)
570510-001-00 rev A
Page 27 of 50