Alderlea T5 Manuel d'installation et d'utilisation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Alderlea T5. Alderlea T5 20 pages.

020512-20 ALT5

Lighting for the First Time

Curing of the Paint Finish
To achieve the best fi nish, the paint on your stove must be baked on. When burning your
stove for the fi rst 2-3 times it is very important that the room be well ventilated. Open all
windows and doors. Smoke and fumes caused by the curing process may cause discomfort
to some individuals.

Lighting a Fire

WARNING: Never use chemicals or any other volatile liquid to start a fi re.
1.
Adjust air control to maximum fi ring position (start position) and open door.
2. Place crumpled newspaper in the centre of the heater and criss-cross with several
pieces of dry kindling. Add a few small pieces of dry wood on top.
3. Ignite the paper and close the door.
4. After the fi re has established itself, open the door and add a few small logs. Close the
door.
5. Begin normal operation after a good coal base exists and wood has charred.

Normal Operation

1.
Set air control to a desired setting. If smoke pours down across the glass (waterfall
effect) this indicates you have shut the control down too soon or you are using too low
a setting. As every home's heating needs vary (based on insulation, windows, climate,
etc.) the proper setting can only be found by trial and error and should be noted for
future burns.
2. To refuel, adjust air control to high, and give the fi re time to brighten. Open the door
slowly, this will prevent backpuffing.
3. Use wood of different shape, diameter and length (up to 18"). Load your wood endwise
and try to place the logs so that the air can fl ow between them. Always use dry wood.
4. Do not load fuel to a height or in such a manner that would be hazardous when opening
the door.
5. For extended or overnight burns, unsplit logs are preferred. Remember to char the wood
completely on maximum setting before adjusting air control for overnight burn.
WARNING: Always keep loading door closed when burning. This heater is not designed
for open door burning.
WARNING: No alteration or modifi cation of the combustion air control assembly is
permitted. Any tampering will void warranty and could be very hazardous.
WARNING: Do not use grates or andirons to elevate the fuel. Burn directly on the fi re
bricks. Replace broken or missing bricks. Failure to do so may create a hazardous
condition.
13