Zanussi ZSF2430 Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZSF2430. Zanussi ZSF2430 16 pages.
Également pour Zanussi ZSF2430 : Manuel de l'utilisateur (32 pages)
Imprimer la page
Alarm code
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 1 time intermittently.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 2 times intermittently.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before
you do the checks.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate the ap-
pliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes appear, contact the Serv-
ice.
www.zanussi.com
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a lower
position.
• The quantity of detergent is too much.
Problem
11