Zanussi ZFG06400WA Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Zanussi ZFG06400WA. Zanussi ZFG06400WA 12 pages.
Également pour Zanussi ZFG06400WA : Manuel de l'utilisateur (12 pages)
Imprimer la page
Door reversibility
The side at which the door opens can be
changed from the left side
to the right side (as supplied), if the
installation site requires.
Warning!
When changing the side at which the door
opens, the appliance must not be connected
to the mains. Remove plug from the mains
beforehand.
1. Screw
2. Low Hinge
3. Upper Hinge
4. Adjustable Low Foot
5. Adjustable High Foot
6. Screw Bolt
7. Plug
8. Decoration Block
9. The block of the top cover
10. Top Cover Plate
11. Screw nail
1. Remove the screw nails (11).
2. Keep the door open, raise the end of the
10
10
HR
EN
10
11
10
7
9
8
top cover, push it(10) frontad and take
it off from the block(9) of the top cover,
then move the bottom block(8).
3. Remove the two screws blot (6) that
connect the upper hinge (5) on the right
side of the cabinet top.
4. Carefully lift the door and place it on a
padded surface to prevent scratching.
5. Remove the plug (7) and transfer it to the
uncovered hole on the right side of the
into the hole.
6. Remove the two screws(6) that hold the
lower hinge (2) on the right side of the
unit.
7. Remove the screw-type leveling front
leg (4) and transfer it to the right side as
8. Set the door into it's new place making
sure the pin enters the bushing at the
lower frame section (hole).
9. Secure the upper hinge (5) previously
removed in step 3 on the left side of the
unit. Make sure the pin enters the bushing
on the upper frame section (hole).
10. Loosely secure the lower left hinge (2)
and do not tighten the bolts until the door
is in the closed position and leveled.
11. Insert the plug (7) on the uncovered
holes (right side).
12. Fix the decoration block(8)in the right of
the top cover plate(10).
13. Keep the door open, raise the end of the
top cover, pull it(10) backwards to hitch
the block(9).
14. After the assembly of the top cover, close
screw(11).
www.zanussi.com