Alecto WS-4800 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Alecto WS-4800. Alecto WS-4800 17 pages. Weather station with wireless outdoor sensor
Également pour Alecto WS-4800 : Manuel de l'utilisateur (16 pages)

Imprimer la page

Indoor unit:

Slide down the battery cover at the rear of the unit and insert 3 AA 1.5V batteries according to the markings

inside the battery compartment. Slide the battery cover back onto the indoor unit. (Batteries are not included)

The indoor unit will now start a 1 minute scan to search for the outdoor unit. Therefore, you'll need to

insert the batteries into the outdoor unit within that minute.

Outdoor unit:

Open the battery compartment by loosening the battery cover using a small

crosshead screwdriver. Install 3 AA 1.5V batteries according to the picture

below, paying attention to the correct polarity (+ and -). Replace the cover and

fasten the screw (batteries are not included).

3.2 Pairing the indoor unit/outdoor unit:

Automatically:

As soon as you insert the batteries into the indoor unit, the indoor unit will start a 1 minute scan to

search for the signal of the outdoor unit. Therefore, if you insert the batteries into the outdoor unit within

that minute and the units will 'find' each other, they will be automatically paired and the display of the

indoor unit will show the temperature transmitted by the outdoor unit.

Manually:

If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor unit

(again) with the indoor unit as follows:

1. press and hold the SCAN button on the indoor unit for 2 seconds until the

flashing in the display

2. Press briefly press the RESET button on the outdoor unit

3. the units will have found each other (again) after several seconds

3.3 Positioning: reset

Indoor unit:

You may suspend the indoor unit from a simple screw in a wall or use it as a desk model

with the supplied support. In any case, never place the indoor unit in direct sunlight or next

to heat radiating lights or stoves.

Outdoor unit:

You may place the outdoor unit on a flat surface (such as a fence or railing)

or on top of a pole (not included). In any case, make sure the unit is placed

at least 1.5 meters above the ground and ensure the unit is standing freely

in the rain and wind.

Outdoor unit positioning tips:

To ensure that the rain meter is functioning as accurate

as possible, the outdoor unit must be standing exactly

horizontal. You can verify this by using the built-in spirit

level at the top of the outdoor unit.

To be able to check from which direction to wind is

coming, the outdoor unit should be aimed to the North. To do this, use the N

marking on top of the outdoor unit. Use an accurate compass (not included)

to properly orient the unit.

Make sure that the distance between the outdoor unit and indoor unit is no

greater than 50 to 100 meters.

antenna symbol starts

reset

>1,5m