Alemite 586-D Instructions d'utilisation et d'entretien - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Alemite 586-D. Alemite 586-D 16 pages. Cordless grease gun (battery charger included)
Imprimer la page
Maintenance
Your Alemite tool has been designed to
operate over a long period of time with a
minimum of maintenance.
Continuous satisfactory operation
depends upon proper tool care and regular
cleaning. Your charger does not require any
maintenance apart from regular cleaning.
Regularly clean the ventilation slots in
your tool and charger using a soft brush or
dry cloth.
WARNING
Before performing any maintenance on
tool, remove battery from tool. Unplug
charger before cleaning.
Failure to comply may result in death
or serious injury.
• Regularly clean motor housing using a
damp cloth.
• Do not use any abrasive or solvent-based
cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Protect environment
Separate collection. This product
must not be disposed of with
normal household waste
Should you find one day that your Alemite
product needs replacement, or if it is of no
further use to you, do not dispose of it with
household waste. Make this product availa-
ble for separate collection.
Separate collection of used
products and packaging allows
materials to be recycled and used
again. Use of recycled materials
helps prevent environmental pollution and
reduces demand for raw materials
Local regulations may provide for sepa-
rate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
Batteries
Run battery down completely, then
remove it from too.
NiCd, NiMH and Li-Ion batteries
are recyclable. Take them to any
authorized repair agent or local recycling.
Additional safety
instructions for
batteries and
chargers
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not store in locations where the
temperature may exceed 104 °F.
• Charge only at ambient temperatures
between 50 and 104 °F.
• Charge only using charger provided with
tool.
• When disposing of batteries, follow
instructions given in section
Protect environment.
• Do not attempt to charge damaged
batteries.
Chargers
• Use your Alemite charger only to charge
the battery supplied with your tool.
Other batteries could burst, causing per-
sonal injury and damage.
• Never attempt to charge non-rechargeable
or defective batteries.
• Have defective cords replaced
immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
.
12