Alemite 3575 Series Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alemite 3575 Series. Alemite 3575 Series 8 pages. Oil control handle with mechanical meter

Imprimer la page

SER 3575A

Lever And Valve

Removal

1 Using a 2.5 mm Allen key, remove the 2

handle screws (36).

C a u t i o n

Maintain control of swivel. Swivel is un-

der spring tension.

Failure to comply may result in minor or

moderate injury.

2 Remove lever (40).

3 Remove the backup ring (22), O-Ring (23),

then push the valve cam (24) from the han-

dle body (26), and remove O-Ring (25).

Control Handle

Reassembly

1 Clean and inspect all parts. Replace any sus-

pect, worn or damaged components.

Notice

Lightly lubricate the valve cam

(24) before assembly.

2 Place O-Ring (23) onto valve cam (24).

Notice

Cut out section in middle of

valve cam (24) must face inlet swivel

(33).

Alemite, LLC

3 Replace the valve cam (24) into the body

(26). Note the orientation shown on the as-

sembly drawing. Fit the second O-Ring (25)

and backup ring (22).

4 Slide lever assembly (40) into position and

replace the two Allen screws (36). (Use

thread locker or similar sealant).

5 Replace plunger (28).

Notice

End hole in plunger must face

meter.

6 Assemble the valve seal assembly (29), and

spring (30) then replace into the handle

body.

Notice

Install spring, small end first.

7 Replace handle sleeve (27).

8 Replace washer (32), O-ring (31) swivel as-

sembly (33) and screw firmly into place

(Use thread locker or similar sealant).

Notice

After assembly ensure handle

latch operates correctly.

Mechanical Meter Oil Control Handle

Initial Release 10-15