ABBA STB16 Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ABBA STB16. ABBA STB16 4 pages. 12v landscape light specialist

Imprimer la page

fixture(s) must be installed in accordance with all local codes and ordinances.

Do not instal within 10 feet of a pool, spa or fountain

To ensure optimal performance and safety, it is

important to use our fixtures ONLY with a low

voltage

landscape

transformer reduces the voltage from 120V to

12V, making it safe and suitable for outdoor use.

When installing the fixture(s), please follow

these instructions carefully:

1.Before

installation,

the power is turned off for your safety.

2. To attain entry to the fixture, we recommend

carefully removing the screws that are currently

securing it in place. This will allow you to

effectively access and address any necessary

adjustments that may be required.

3. Acquire the enclosed LED strip light from the

packaging. Proceed by peeling off the adhesive

backing from the strip, then meticulously affix it

to the surface of the fixture. Please ensure that

during the application process, the strip is

precisely

aligned

positioning.

4.Hold the FIXTURE against the wall at the

desired height and orientation. Ensure it is level

and aligned according to your preferences.

5.Using a pencil or marker, carefully mark the

screw hole locations on the wall through the

holes in the metal plate.

6.Select an appropriately sized drill bit for the

pilot holes, which should match the diameter of

the screws you are using. It is recommended to

use a bit slightly smaller than the screws to

provide a secure grip.

CAUTION:

INSTALLATION INSTRUCTION

transformer.

This

please

ensure

that

achieve

centered

www.ABBALightingUSA.com

7. Position the drill bit on each marked spot and

gently drill pilot holes into the wall at the marked

locations. Take care not to drill too deep, ensuring

the depth matches the length of the screws.

8.For concrete installation, To begin, construct

conduit raceways inside the concrete formwork by

using one-inch dowels and PVC pipe before

pouring the concrete. After the concrete has

cured, remove the dowels and proceed to finish

the outer surface of each riser if you are installing

it in stairs.

We recommend using WN12 waterproof wire nuts

(sold separately) for optimal connectivity.

9.Strip the insulation: Carefully strip approximately

3/4 inch (1.9 cm) of insulation from the ends of the

two wires you wish to connect. Ensure that the bare

metal ends are clean and free from any frayed

strands.

10. Align the wires: Hold the stripped ends of the

two wires together, aligning them neatly and

ensuring that no stray strands are crossing over.

11. Insert the aligned ends of the wires into the wire

nut, ensuring that they go all the way in. The bare

ends should be completely covered by the wire

nut. Twist the wire nut: Firmly twist the wire nut

clockwise onto the wires, ensuring a secure

connection. Continue twisting until the wire nut is

tight

and

snug.

For

recommended to apply electrical tape around the

wire nuts and wires as an extra layer of protection.

12.Test the connection: Gently tug on each wire to

ensure they are securely held by the wire nut.

added

safety,