ARO PD02P series Manuel de l'opérateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} ARO PD02P series. ARO PD02P series 8 pages. 1/4" diaphragm pump

Imprimer la page

OPERATOR'S MANUAL

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.

SERVICE KITS

Refer to Service Kit Chart to match pump material with Service Kits of

fered. The X" represents a variable digit of the Model Number.

637276 Air Valve Kit.

637313 XX for Pump Wet End Repair (model digits 7 and 11).

637314 XX for Pump Rebuild (model digits 7 and 11).

PUMP DATA

Models

. . . . . . .

see Model Description Chart" for XXX".

Pump Type

. . . .

Non Metallic Air Operated Double Diaphragm.

Material

. . . . . . .

see ``Model Description Chart".

Weight

. . . . . . . .

Polypropylene

Groundable Acetal

PVDF (KynarR)

Maximum Air Inlet Pressure

Minimum Air Inlet Pressure

. . . . . . . . . .

Maximum Outlet Pressure

. . . . . . . . . . .

Maximum Flow Rate

. . . . . . . . . . . . . . .

Maximum Suction Lift

. . . . . . . . . . . . . .

Maximum Output Per Cycle

. . . . . . . . . .

Maximum Particle Size

. . . . . . . . . . . . .

Maximum Temperature Limits

Polypropylene

Groundable Acetal

PVDF (Kynar)

Groundable

. . . . . . . . . . . . . . . . .

Dimensional Data

. . . . . . . . . . . . . . . . .

Noise Level @ 70 p.s.i., 60 c.p.m.

The pump sound pressure levels published here have been updated to an Equivalent Continuous Sound

Level (L

) to meet the intent of ANSI S1.13 1971, CAGI PNEUROP S5.1 using four microphone locations.

Aeq

NOTICE: All possible options are shown in the chart. However, certain

combinations may not be recommended, consult a representative or the

factory if you have questions concerning availability.

GENERAL DESCRIPTION

The ARO Diaphragm Pump offers high volume delivery even at low air pres

sures, easy self priming, the ability to pump various viscosity materials and

the ability to pass solids (as stated in the chart above). The pump is designed

to correspond to the needs of the user by offering a variety of wetted parts

configurations to handle almost any application.

Air operated double diaphragm pumps utilize a pressure differential in the

air chambers to alternately create suction and positive fluid pressure in the

fluid chambers. Flat checks insure a positive flow of fluid.

Pump cycling will begin as air pressure is applied and it will continue to pump

and keep up with the demand. It will build and maintain line pressure and will

stop cycling once maximum line pressure is reached (dispensing device

closed) and will resume pumping as needed.

Model PD02P XDS DTX: The Acetal material used in this pump contains

Stainless Steel fibers. It's conductivity allows it to be connected to a suitable

ground. A ground screw is provided for this.

INGERSOLL-RAND COMPANY

P.O. BOX 151

ONE ARO CENTER

(419) 636-4242

FAX (419) 633-1674

1/4" DIAPHRAGM PUMP

1:1 RATIO (NON-METALLIC)

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

. . . . . .

4.08 lbs (1.85 kgs)

. . .

4.64 lbs (2.10 kgs)

. . . . .

4.9 lbs (2.22 kgs)

. . . . . . . . .

100 p.s.i.g. (6.9 bar)

20 p.s.i.g. (1.4 bar)

100 p.s.i.g. (6.9 bar)

4.6 g.p.m. (17.4 liters)

20 ft. (water)

0.014 gallons (53 cc's)

clean fluid only

. . . . .

35_ to 150_ F (2_ to 66_ C)

. .

10_ to 180_ F ( 12_ to 82_ C)

. . . . .

10_ to 200_ F ( 12_ to 93_ C)

PD02P XDS DTX models only.

see page 8.

. . . . .

59.8 db(A)

BRYAN, OHIO 43506 0151

2001 D PRINTED IN U.S.A.

PD02P XXS XTX

1/4'' DIAPHRAGM PUMP

MODEL DESCRIPTION CHART

CENTER BODY MATERIAL

P - Polypropylene

INLET / OUTLET

A - Single Inlet / Single Outlet

D - Single Inlet / Double Outlet

E - Double Inlet / Single Outlet

H - Double Inlet / Double Outlet

WET END / FLUID CAP / MANIFOLD MATERIAL

D - Groundable Acetal

K - PVDF (Kynar

)

P - Polypropylene

HARDWARE MATERIAL

S - Stainless Steel

CHECK VALVE SEAT MATERIAL

D - Groundable Acetal

K - PVDF (Kynar)

P - Polypropylene

CHECK MATERIAL

T - T.F.E. (Teflon

)

DIAPHRAGM / O" RING MATERIAL

A - Santoprene

/ E.P.R.

G - Nitrile / Nitrile

T - T.F.E. (Teflon) / T.F.E. (Teflon) / Nitrile

FLUID SECTION SERVICE KIT SELECTION

EXAMPLE: MODEL # PD02P ADS DTA

FLUID SECTION SERVICE KIT # 637313 DA

PD02P-X

RELEASED:

10-1-96

REVISED:

7-11-01

(REV. J)

PD02 P X X S X T X

PD02P X X S X T X

637313 X X

Wet End Material

Diaphragm Material