ARO SQ054C Manuel de l'opérateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} ARO SQ054C. ARO SQ054C 8 pages. 50 series qrt

Imprimer la page

OPERATOR'S MANUAL

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

SECTION

M30

MANUAL

Released:

4-2-90

50 SERIES "QRT" SCREWDRIVERS

Revised: 10-30-95

Form:

3645-2

Models: SQ054C-( )-( )

READ THIS MANUAL

CAREFULLY

BEFORE

INSTALLING,

OPERATING

OR SERVICING

THIS EQUIPMENT.

FAILURE TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

Pneumatic tools should always be installed and used in accor-

dance with A.N.S.I. 8188.1 "Safety Code For Portable Air Tools."

Repeated prolonged operator exposure to vibrations which may

be generated in the use of certain hand-held tools may produce

Raynaud's phenomenon, commonly referred to as Whitefinger

disease. The phenomenon produces numbness and burning

sensations in the hand and may cause circulation and nerve dam-

age as well as tissue necrosis. Repetitive users of hand-held

tools who experience vibrations should closely monitor duration

of use and their physical condition.

Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure

at the air inlet of the tool.

Disconnect air supply from tool before removing/installing bit,

socket or device attached to tool or performing maintenance

procedures.

Keep hands, clothing and long hair away from rotating end of

tool.

Anticipate and be alert for sudden changes in motion during

start up and operation of any power tool.

Never exceed rated r.p.m. of tool.

Wear suitable eye and hearing protection while operating tool.

Tool shaft can continue to rotate briefly after throttle is re-

leased.

Do not lubricate tools with flammable or volatile liquids such as

kerosene, diesel or jet fuel.

Do not remove any labels. Replace any damaged label.

Use only accessories recommended by ARO.

The use of other than genuine ARO replacement parts may

result in safety hazards, decreased tool performance and in-

creased maintenance and may invalidate all warranties.

ARO is not responsible for customer modification of tools for

applications on which ARO was not consulted.

Tool maintenance and repair should be performed by autho-

rized, trained, competent personnel. Consult your nearest

ARO authorized servicenter.

It is the responsibility of the employer to place the information

in this manual into the hands of the operator.

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution

Center, White House, TN at PH: (615) 672-9321, FAX: (615) 672-0801.

ARO Tool Products

Ingersoll-Rand

Company

1725 U.S. No. 1 North

P.O. Box 8009

Southern Pines, NC 28388-8000

PRINTED

IN U.S.A.

Part of worldwide Ingersoll-Rand