3D Upfitters AnkerMake M5 Manuel d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18 pages.

Imprimer la page

6. Install Vents

Before installing the front vents it would help if you placed the enclosure over the 3D

printer at this point.

The front fresh air vent is inserted from the outside and attached using M4 12mm

screws. This will bring cold air to the air intake vent of the case, cooling the electronics

inside. It's essential to keep the fan on the back panel running to help draw air through

the case's vents and outside when printing PLA and PETG.

Once you've secured the vents as shown above, place the lids on top. The lid ﬁts right

into the vent slots, helping to form a seal. Slide the 3D printer towards the front up

against the vent.