artograph 225-995 Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} artograph 225-995. artograph 225-995 12 pages. Digital art projector tripod

Imprimer la page

Extending Legs

To extend the tripod legs, release the Locking Levers

on each leg section and slide the leg to a desired length.

To lock, firmly push the lever back into place to secure the

section in place. Repeat this process for the remaining

legs to achieve desired height. Ensure that all of the

Locking Levers have been properly locked before use.

If the ground is not even, the legs can be extended to

different lengths.

Height Adjustment

The height of your tripod can be further increased by

raising the center column. Loosen the Center Column

Locking Knob to unlock the center column of the tripod

and raise to desired height and tighten knob.

Attaching Projector

to Tripod

First, ensure that Ball Head Knob is tight before

proceeding. Loosen the Platform Locking Knob and

depress the Platform Locking Pin on the side and slide

Projector Platform outward from the ball head. Remove

the platform and attach it to the bottom of the projector by

placing the Tripod Pad on the bottom of the projector over

the screw mount opening. Tighten the thumb screw on

the platform until it is snug to the base of the projector. Do

not over tighten. Fold the thumb screw down flat. Replace

the platform back onto the ball head in the original position

by pushing in locking pin and sliding platform back into

position and then tighten locking knob.

Caution: Ensure that the Ball Head Knob is in a

tightened position before mounting projector.

Operating the Ball Head

Horizontal Projection

For horizontal panning, loosen the Panning Locking

Knob, which will allow the ball head to move left or right

horizontally. Tighten the panning locking knob to secure a

horizontal position. To tilt the ball head up or down, loosen

the Ball Head Knob and while holding the projector firmly,

move the ball head to desired position, retighten knob.

Caution: Do not let go of the projector without first

locking the ball head into position.

(Fig. 2 & 3)

(Fig. 4)

(Fig. 5, 6 & 7)

(Fig. 8)

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8