ASL INTERCOM TS-120 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol ASL INTERCOM TS-120. ASL INTERCOM TS-120 7 halaman. Cue light system
Halaman Cetak12.0 USING THE TS-99 PRESET CONTROL
With the TS-99 one may operate a cue light system consisting of one TS-120 and a number of connected
TS-10‟s. One can store up to 99 „Cue‟ presets and control the ATTN, GO and CLEAR button of the TS-120‟s
using the ATTN and GO buttons of the TS-99.
When several TS-120‟s are linked one has to operate such a system with the TS-99 to make it a one multi-
channel (max. 144) cue light system.
Programming & storing a preset:
a. Select the requested preset number with
the "left" and "right" SELECT PRESET
buttons
b. Push the PROGRAM button.
The TS-120‟s are now in „program mode‟
and show the content of the chosen preset
number: the LED‟s of the channels in this
preset are flashing green
c. Push the GO buttons of the channels you
want to add to this preset.
Push the GO buttons of the channels you
want to remove from this preset
d. To store the just (re-) configured preset,
push and hold the STORE button until the
TS-120‟s go out of their program mode and
return to normal operation
Previewing a preset:
a. Select the requested preset number with
the "left" and "right" SELECT PRESET
buttons
b. Push and hold the PREVIEW button. The
content (if any) of the selected preset is
shown on the TS-120‟s:
The LED‟s of the in this preset stored
channels are flashing green
PAGE 7
User Manual TS 120 / March 2011 © ASL Intercom BV
.
Activating a preset ('attention' and 'go'):
a. Have a look at the display. In case there is
a preset presently active (in an Attention
and Go sequence) this is indicated by a
blinking dot next to the preset number.
Before another preset can be selected, the
Attention and Go sequence of this active
preset must first be completed
b. Select the requested preset number with
the "left" and "right" SELECT PRESET
buttons
c. Push the ATTN button on the TS-99. All
channels stored in the selected preset go
into attention mode and the attention signal
is sent to the corresponding TS-10‟s
d. Push the GO button on the TS-99.
All channels stored in the selected preset
go from ATTN to GO (the corresponding
LED‟s go from red to green) and the GO
signal is sent to the to the referring TS-10‟s
e. Push the GO button on the TS-99 again.
All channels are now cleared:
the LED‟s on the TS-120‟s and the GO
lights on the TS-99‟s extinguish
f.
One may select another preset and start
the next „attention‟ and „go‟ sequence
Between step c. and d. there might be an
„acknowledgement‟ phase: from the TS-
10‟s an acknowledgement signal has been
sent to the corresponding TS-120
channels.
Whether an acknowledgement signal has
been received is not shown on the TS-99,
only on the TS-120„s (the LED‟s of the
referring channels go from flashing red to
constantly red).