ACR Electronics The Buxton BX1MF Panduan Teknis - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Kompor ACR Electronics The Buxton BX1MF. ACR Electronics The Buxton BX1MF 20 halaman.

Instructions for use with wood
 Slide the top air control to the right and pull open the primary air fully.
 Lay firelighters or rolled up newspapers on the grate and add a small
amount of kindling wood to the top. Place 1 or 2 small logs on the top.
 Light the newspaper or firelighters using a long taper and push the
door to.
 When the fire is burning fiercely, after a couple of minutes add more
logs and close the door.
 When the fire has become established, close the primary air down.
 The burning rate can be altered by moving the top air slide.
 Care should be taken to ensure that the logs are not placed higher
than the log guard allows.
The air controls should not be adjusted except as directed in these
instructions
Instructions for use with smokeless fuel
 Slide the top air control to the right and open the primary air fully, fully
close the tertiary air tabs at the rear of the appliance.
 Lay firelighters or rolled up newspapers on the grate and add a small
amount of kindling wood to the top.
smokeless fuel on top.
 Light the newspaper or firelighters using a long taper and push the
door to.
 When the fire is burning fiercely, after a couple of minutes add more
smokeless fuel and close the door.
 When the fire has become established, close the top air down.
 The burning rate can be altered by moving the primary air slide.
 Care should be taken to ensure that the firebox is not overfilled with
smokeless fuel – it should be no higher than the log guard.
Re-fueling
When refueling the stove always refuel onto a bed of hot embers, fully
open the secondary air control and leave the door slightly ajar for a few
minutes or until the new fuel is well alight, before closing the door and
adjusting the air controls for the desired setting.
If there is insufficient burning material in the firebed to light a new fuel
charge, excessive smoke emission can occur. Refueling must be carried
out onto a sufficient quantity of glowing embers and ash that the new fuel
charge will ignite in a reasonable period. If there are too few embers in
the fire bed, add suitable kindling to prevent excessive smoke.
Place a small quantity of