Canon 900D - i Color Inkjet Printer Manual Pencetakan - Halaman 43
Jelajahi secara online atau unduh pdf Manual Pencetakan untuk Printer Canon 900D - i Color Inkjet Printer. Canon 900D - i Color Inkjet Printer 48 halaman. Bubble jet printer direct printing guide
Juga untuk Canon 900D - i Color Inkjet Printer: Petunjuk Penyiapan (2 halaman), Manual Pencetakan (4 halaman), Manual Pencetakan (50 halaman), Panduan Memulai Cepat (29 halaman), Manual Pencetakan (30 halaman)
Halaman Cetak
Troubleshooting
Let's take a look at countermeasures against troubles which may occur during use of the printer.
Here, we will discuss errors indicated on the LCD, problems that might occur during direct printing
from the digital camera, and problems that are also likely to occur while using the Photo Viewer. If
you cannot find the symptom corresponding to a certain problem, refer to the User's Guide.
"A Message is Displayed on the LCD" on page 42
"Ink does not come out/ Printing is Blurred/ Colors are Wrong/ White Streaks" on page 44
"Printed Surface is Scratched" on page 44
"Cannot Print Properly from the Digital Camera" on page 45
"An Error Message is Displayed While Using the Photo Viewer" on page 46
A Message is Displayed on the LCD
If a message is displayed on the LCD, take the corresponding countermeasure described below.
Message
No images.
Waste ink tank almost full.
Read-write mode enabled.
Failed to align print head
Cannot communicate with
digital camera.
42
Image data edited/processed on the computer should be printed from
the computer, not from the camera.
Press the Resume button to recover from the error.
You can print images for a while but you cannot print any more image
when the waste ink tank becomes full. Contact a Canon service
representative.
The memory card utility started on the computer has write-enabled the
card slot. When the card slot is write-enabled, the printer cannot print
images.
When you have finished writing data to the card, select the read-only
mode. For the cancellation procedure, see "Setting up the Card Slot as
the Memory Card Drive of the Computer" on page 29.
Press the Resume button and follow the procedure below.
(1) Open the front cover and check if there is ink left. If there is no ink
left, replace the ink tanks
See "Replacing Ink Tanks" on page 35.
(2) Print the nozzle check pattern to verify that the print nozzles are
clean.
See "Printing the Nozzle Check Pattern" on page 38.
(3) Move the printer so that the paper output is not in direct sunlight
and try automatic print head aligning again.
(4) If the error persists, adjust the print head manually.
Disconnect the camera connection cable, press the Resume button,
and then connect the cable once more.
The digital camera should be turned on automatically. If not, turn it on
manually.
Try This