Air & Allied Sales MP55AK Buku Petunjuk - Halaman 5
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Air & Allied Sales MP55AK. Air & Allied Sales MP55AK 11 halaman. Air nipper
Halaman Cetak・Use the appointed accessories.
Please do not use anythings other than the accessories of the specification
written in this operation manual and our catalog .
Since there is a possibility of becoming a cause of accidents, such as an injury.
・The use by an abnormal condition causes an injury and breakage of the body.
Request repair from the store or our company of a purchase in the case of abnormalities.
Neglect neither this machine nor an air compressor, hit to direct rays for a long time.
This machine should repair carefully.
When you do not use it, please keep it exactly.
Do not remove parts or do not convert.
I will carry out the product given unjust decomposition and reconstruction
the outside of the object of a guarantee.
No responsibility for the failure accompanying a user's own reconstruction act or fault is taken.
Periodic check list
Time of check
It is the existence of slack or breakage to screw pin（⑥） part.
Existence of an air leak of air pin（④）.
Before work
Existence of an operation in the state where the valve switch was closed
The crack in an appearance side, and the existence of a crack
Existence of slack of a lever part（⑧）
At the time
It is checked whether the spring and the piston and
of work
the lever are operating normally.
※It recommends exchanging pistons in six months.
・How to bind tight in case screw pin(⑥) has slack
(1) Intercept an air source of supply.
(2) Remove an air hose from a main part. (Refer to Fig. 1)
(3) Fasten a screw pin(⑥) with a minus driver and be crowded with the state
where the nut(⑮) was made to fix with a spanner etc.
Fig. 1
・The exchange method of screw pin(⑥)
(1) Intercept an air source of supply.
(2) Remove an air hose from a main part. (Refer to Fig. 1)
(3) Please loosen screw pin(⑥) with a minus driver in the state
where nut(⑮) was made to fix with a spanner etc., and remove nut(⑮). (Refer to Fig. 2)
(4) Extract screw pin(⑥) and replace with a new screw pin.
※Keep in mind that it will be in the state where blades separate when screw pin(⑥) is removed.
Fig. 2
Check
5/11
Air & Allied Sales (Pacific) Pty Ltd
Do
It is. → Bolting or part exchange
It is. → Part exchange
It is. → Maker repair
It is. → Part exchange
It is. → Maker repair
Maker repair or
It is. →
Part exchange
www.air-allied.com.au