AmeriGlide RUBEX Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Pengangkatan AmeriGlide RUBEX. AmeriGlide RUBEX 16 halaman.
Juga untuk AmeriGlide RUBEX: Panduan Pemilik (8 halaman)

Halaman Cetak

Step 4: Loosen the splice bars from their

shipping position and slide them out to half

way. Tighten the splice bars.

Step 5: Slide the upper track section onto

the lower track section. Tighten the splice

bar set screw bracket to lock tracks together.

The tracks will not slide together if the set

screws protrude beyond the splice bar.

Step 6: Attach track brackets to the side of the

top track section. Hand tighten.

SLACK CABLE RESET PROCEDURE

Step 1: During shipping, the slack cable device may engage and need to be

reset.

shaft and rotate clockwise. This will slowly inch the unit up the track.

If you see the lift begin to move uphill or hear a click, that will tell you that the

slack cable has reset.

Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648

10 //

Step 2: With the unit and upper track section installed

and power cable unplugged, you will use the hand

crank to turn the motor belt that turns the cable drum.

The illustrations show overhead and cut-away

views of the unit.

Step 3: Place the manual hand crank onto the motor

11819 P/N: 16169 Rev D

CAUTION:

Do not put

your fingers

between the

track sections

at any time as

injury could

occur.