AmeriGlide RUBEX Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Pengangkatan AmeriGlide RUBEX. AmeriGlide RUBEX 16 halaman.
Juga untuk AmeriGlide RUBEX: Panduan Pemilik (8 halaman)

Halaman Cetak

11819 P/N: 16169 Rev D

Step 5: Use the track bracket bolts to fasten brackets to

nuts in the track channel.

Position track brackets as follows:

a) 1 bracket pair on bottom step

b) 1 bracket pair on top step

c) 1 bracket pair above and below where the tracks

splice together

Hand tighten the bolts only - the brackets will need to

slide for correct positioning.

Step 6: Splice bars are used to join the track sections

together. Locate the splice bars and loosen the set screw

from their shipping position. Slide the spice bars to half

way and tighten the two set screws remaining in the track

to hold them in place. The tracks will not slide together if

the set screws protrude beyond the splice bar.

Allen Wrench

Step 7: Slide the upper track section onto the

lower track section. Tighten the splice bar set

screws to lock tracks together.

Caution:

Do not put your fingers between the track

sections at any time as injury could occur.

detail of track section showing position of splice bars

Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648

do not remove

foam packaging

Note

Attach a bracket on the bottom

nut, but leave the nut second

from the bottom unused - it will

be used later.

Allen Wrench

7 //