AMERITRON ATP-100 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penguat AMERITRON ATP-100. AMERITRON ATP-100 8 halaman. Tuning pulser

ATP-100 Instruction Manual

Tuning Pulser

The ideal compromise (especially for tuning amplifiers) is achieved when the

PULSE RATE and DUTY CYCLE controls are near the counter-clockwise end

where the power drops off, but adjusted slightly clockwise from the point where

the peak power meter starts to fall back. If such a setting can not be found, it is a

strong indication the meter does not indicate peak power accurately.

Connecting the Ameritron ATP-100 Tuning Pulser

The Ameritron ATP-100 Tuning Pulser connects to the CW Key jack of your

exciter via the Ameritron ATP-100 Tuning Pulser

rear panel jack labeled

"Output". The Output jack is a standard RCA phono plug, with the center pin

connected to the positive voltage keying line (less than 50 volts and 100 mA)

and the outer shell grounded. If the case of the Ameritron ATP-100 Tuning

Pulser is kept isolated from ground, the Ameritron ATP-100 Tuning Pulser can

be used with negative keying line voltage radios provided radio keying line

voltages are below 25 volts. The primary concern is the shock hazard and

potential of accidentally keying the rig if the cabinet of the Ameritron ATP-100

Tuning Pulser or the operator comes in contact with grounded equipment.

WARNING: Never use the ATP-100 with negative keying line rigs

that have over 25 volts on the key jack.

Tuning Amplifiers

Nearly all power amplifiers (PA's) are properly tuned when maximum envelope

power is obtained with full exciter output. Tuning the amplifier to match exciter

peak power prevents gain compression (flat-topping), reduces splatter and

distortion, and reduces the chance of PA damage from arcing.

Maximum average power is directly related to (although considerably less than)

maximum peak power. While the lack of a good peak reading meter prevents

measurement of true peak power, virtually any RF power meter will provide a

correct indication of tuning. When the amplifier is tuned to produce maximum

average power when driven with a constant rate and duty cycle pulse, it is almost

certainly tuned for maximum peak power.

The least damaging and cleanest PA tuning condition generally occurs when the

PA is peaked slightly beyond maximum output, in a direction that OPENS or

UNMESHES the loading capacitor (this capacitor is sometimes called LOAD,

ANTENNA, COUPLING, or MATCHING).