DoorKing 1601-295 Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penghalang Otomatis DoorKing 1601-295. DoorKing 1601-295 11 halaman. Break-away octagon arm installation kit
Juga untuk DoorKing 1601-295: Panduan Pemilik (8 halaman)
Halaman Cetak1601 Octagon Breakaway Arm - Arm Connection
MAKE SURE ALL POWER IS TURNED OFF TO OPERATOR!
Connect Arm to
Wire Harness
Secure Wires to
Breakaway Bracket
Zip tie wires to secure near pivot point
IMPORTANT:
To secure wires to bracket, allow for some slack in the wires to account for the arm pivoting when arm "Breaks Away" from bracket.
Test breakaway feature to make sure there is enough slack in the wires when securing wires.
Breakaway Arm Reset Procedure
If arm gets struck and breaks away, gate operator will automatically shut down (Breakaway sensors are tripped). Simply snap arm back into the
release rollers. Make sure all wires are out of the way of the arm when snapping arm back in position. Normal operation can then continue.
DO NOT OPERATE ARM WITHOUT BREAKAWAY SENSORS FUNCTIONING.
1601-269-G-7-21
Only wire your existing
1601 Octagon Arm
OPTIONAL Red/Green LEDs
See page 10
OPTIONAL Reverse Edge
See page 10
OPTIONAL Rubber Bumper
See page 11
Option #1
Optional
components
1601-401
Magnetic Contact
Normally Close
Battery Backup
1601 Breakaway Bracket
Breakaway Bracket
Breakaway Sensor
Red
Red Connector
White
C7 L8
Breakaway Sensor
NO
Red Connector
White
C6 L7
OPTIONAL
Convienence Open ONLY
Breakaway Sensor
Blue
Blue Connector
Battery Backup C8 L9
Grey
Breakaway Sensor
NC
Blue Connector
Battery BackUp C9 L10
Red
Arm
Pivot
Bolt
Zip tie wires to secure near pivot point
7
DoorKing Part Number
1601-295
Cable Grip
To Operator
See next page
Breakaway Sensors
Cable Grip
Black
Blue
IMPORTANT: Allow
slack in the wire
harness between the
Pink
cable grips of at
least 13" or more
for the rotating arm.
Yellow
Option #2
Arm
Pivot
Bolt