Al Huraiz EVERHOT Manual - Halaman 7
Jelajahi secara online atau unduh pdf Manual untuk Pemanas Air Al Huraiz EVERHOT. Al Huraiz EVERHOT 9 halaman.
Halaman Cetak
Assembly diagram of the support base
on a surface with maximum inclination of 32
ASSEMBLY
INSTRUCTIONS
Before choosing the location and the
installation point, ensure that it is not
shaded by any obstacle (trees, build -
ings... etc, see obstacle diagram here
below).
The same support base is used for
either slopping or flat surfaces.
Connect the plates (A) and (C) so that to
form a parallelogram frame, as shown in
the drawing.
Bend the four (D) plates as shown in the
drawing. Remove the tiles, and place the
bended plates (D) on the wooden tim -
bers or on the concrete of the roof.
Screw tightly the parallelogram frame
(A)+(C) on the plates (D). Plumb the
support base and screw the plates (D)
on the wooden timber of the roof (see
drawing).
Screw the plates (B) on the parallelo -
gram frame (A)+(C). Ensure that the
plates (B) are tightly screwed on the
holes of the plate (A).
Screw gently the bottom plate E on the
plates B.
attention:
The top plate (E) is fixed after
the placement of the collector(s).
note:
The standard support base can
be used also for surfaces with minimum
inclination 15
and maximum 32
o
For smaller or greater inclinations, differ -
ent equipment is offered.
OBSTACLE TABLE
.
o
Latitude
collector and obstacle
0º- 25º
25º- 35º
35º- 45º
45º- 50º
50º- or more
U
Z
C
D
Distance between
A = 1,0 x B
A = 1,5 x B
A = 2,0 x B
A = 2,5 x B
A = 3,0 x B
0
E
U
Z