Dafra DRPB48V Panduan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Dafra DRPB48V. Dafra DRPB48V 13 halaman.

DRPB48V Operation Manual

SETTING UP THE TOOL

Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST included in this
manual in order to have a good understanding of the tool parts described. The descriptions of
the tool parts appear in this manual in italics with the parts position numbers corresponding to
the tool explosive illustration.
1) This pneumatic powered tool should be used with compressed air supply. It is recommended
to use the air hose with diameter bigger than 8 mm.
2) Check that the compressed air pressure is within the specified range between 0.5Mpa and
0.7Mpa, before connecting the air hose onto the tool air adaptor (#52). The air adaptor has
different versions in different countries and areas. Normally the tools are equipped with the
correct version, however if the air adaptor supplied does not match your air supply hose,
contact the tool distributor(s).
3) Change and use correct nosepiece (#1) according to the size of the rivet to be set. This tool
is equipped with nosepieces 3.0mm/3.2mm, 4.0mm and 4.8mm/5.0mm (on the tool) in the
kit. Follow the steps below to change the nosepiece (#1):
a) Remove the air supply hose from air adaptor (#52);
b) Use the wrench (in accessories pack) to remove the nosepiece (#1) from the tool:
a) Select the correct nosepiece in accessories pack and screw on to the tool, using the
wrench to fix it firmly on the tool.
4) To install the mandrel collector (#24, in accessories pack) on the back of the tool.