Baumer OADM 20I5560/S14C Panduan Pengguna - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Baumer OADM 20I5560/S14C. Baumer OADM 20I5560/S14C 30 halaman. Laser distance sensor
Juga untuk Baumer OADM 20I5560/S14C: Manual (2 halaman)
Halaman Cetak
2 Functional principle
The distance measured is based on the triangulation principle. The emitted laser beam falls on the object as
a small light spot and will be reflected diffusely. The position of the received light spot on the receiver (a
diode line) defines the receiving angle. This angle corresponds to the distance and is the base for the
internal calculations.
A distance change close to the sensor effects a large change in angle; the same distance change at the end
of the measuring range has a much smaller effect to the angle. This non-linearity feature is linearized by the
microcontroller. The analog output signal is linear to the distance.
The sensor adapts automatically to different object colors by varying the emitting laser intensity and
optimizing the exposure time. The result is a sensor that is nearly independent on different reflections
(different colors, shiny surfaces, dark objects). The sensor reaches its highest accuracy if the object reflects
diffusely.
3 Mounting instructions
For a proper mounting, the mounting surface has to be flat. Be aware of the max. tightening torque.
In case of EMC, the sensor has to be grounded and a shielded cable has to be used.
The 90° rotating connecter allows wiring the sensor from the bottom side or from the rear.
The max. accuracy will be reached >15 minutes after power on.
BA_OADM20x5.doc ANW_81253059
03.07.2017
Diode line with
receiving light spot
Object close to sensor
Object far away
18/30
Baumer
Frauenfeld, Switzerland