Baumer Hubner HMC16 Series Petunjuk Pemasangan dan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan dan Pengoperasian untuk Konverter Media Baumer Hubner HMC16 Series. Baumer Hubner HMC16 Series 44 halaman. Encoder without bearings - incremental

Halaman Cetak

Baumer Hubner HMC16 Series Petunjuk Pemasangan dan Pengoperasian

TABLE OF CONTENTS

7. SETTINGS HMCP16 ��24

7�1 Removing the cover ��24

7�2 Pin headers on the electronic board ��25

7�2�1

Electronic board version 1 ��25

7�2�2

Electronic board version 2 ��25

7�3 Adjustment of the interpolation of the pulses (cycles) ��26

7�4 Adjustment of the frequency output ��27

7.5 Adjustment of the envelope delay time of the filter ��28

7�6 Adjustment to skeleton operation ��28

8. FILTER DIAGRAMS HMCP16 ��29

8.1 Filter setting „00" (range 150 µs) ��29

8.2 Filter setting „01" (range 300 µs) ��29

8.3 Filter setting „02" (range 500 µs) ��30

8.4 Filter setting „03" (range 1000 µs) ��30

8�5 Filter setting „10" (range 0�5 ms) ��31

8�6 Filter setting „11" (range 1 ms)��31

8�7 Filter setting „12" (range 2 ms) ��32

8�8 Filter setting „13" (range 4 ms) ��32

9. DISMOUNTING ��33

9�1 Dismounting the signal processing electronic HMCP16 ��33

9�2 Untighten the clamping ring screw ��33

9�3 Removing the rotor from the drive shaft ��34

9.4 Unscrewing the fixing screws of the stator ��34

9�5 Screwing in the jack screws in stator ��35

9�6 Getting off the stator from the drive shaft ��35

10. TECHNICAL DATA ��36

10�1 Technical data - electrical ratings ��36

10�2 Technical data - mechanical design (HMCR16 + HMCK16) ��38

10�3 Technical data - mechanical design (HMCP16) ��38

MB168T1EN - 11184527, 19A2, Baumer_HMC16-T1_II_EN