AmpliVox AirVox SW695 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Pembicara AmpliVox AirVox SW695. AmpliVox AirVox SW695 12 halaman. Battery powered pa system with bluetooth

Halaman Cetak

BATTERY COMPARTMENT

BATTERY REPLACEMENT

The AmpliVox AirVox has two (2) SLA (Sealed Lead Acid)

batteries located at the front behind the metal plate that is

behind the grille. To remove grille, take a paper clip and

hook it thru a hole and pull until grille releases. (Fig. 1).

To access the battery compartment, remove the eight (8)

screws and remove plate. Set aside.

You will now notice foam blocks that hold the two batter-

ies in place preventing them from bouncing around in the

compartment (Fig. 2).

Remove the foam blocks and set aside. Slowly pull out

the batteries one at a time. Because the batteries have a

wiring harness attached they will only pull out so far.

Stand batteries up as shown (Fig. 3). You will now see on

each battery there are two wires, one RED (+) and one

BLACK (-). The RED wire is connected to the battery ter-

minal that has a RED DOT. Remove both wires from each

battery.

You will notice that there is a black tube also attached to

these wires. This is a fuse holder (Fig. 4). The fuse inside

is a type 2AG Glass Body. These fuses used to be very

common in automobiles and are sold at automotive part

stores if you need to replace it. This fuse acts as a protec-

tion circuit should you attach the wires incorrectly to the

battery.

Take your new batteries and reconnect. RED wire to RED

DOT (+) on battery. BLACK wire to other terminal (-).

Once wires are firmly attached to the terminals lay the

batteries on their side and slide back into battery compart-

ment. Remember to also install the foam blocks as shown

in (Fig. 2).

Take metal plate and screw back into place using the

eight (8) screws.

Push grille back into place.

Charge new batteries for 24 hours before using.

IMPORTANT BATTERY INFORMATION

All SLA batteries self-discharge at a rate of approxi-

mately 5% per month. If the capacity loss, due to self-

discharge is not compensated for by recharging, the

battery capacity may not be recoverable. The batteries

will have to be replaced. Charge batteries at least every

six (6) months, or charge after every use.

Your PA has a "SMART" charging circuit. Leaving the

battery charger always connected is OK. It will not over-

charge your batteries.

Only use the charger that came with the PA. Using any

other charger may damage batteries.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fuse Holder