AmpliVox TITAN WIRELESS SW800-96 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Pembicara AmpliVox TITAN WIRELESS SW800-96. AmpliVox TITAN WIRELESS SW800-96 12 halaman. Titan wireless battery powered pa system
Juga untuk AmpliVox TITAN WIRELESS SW800-96: Panduan Pengguna (12 halaman)
Halaman CetakACCESSORIES
TROUBLESHOOTING GUIDE
PROBLEM & ITEMS TO CHECK
UNIT WILL NOT TURN ON
• Is unit plugged in?
• Are batteries charged?
• Is fuse blown?
UNIT OPERATES ON AC BUT NOT
BATTERY
•
Check battery terminals.
SOUND IS DISTORTED
•
Turn down input source (such as
keyboards, etc.) since the output of some
devices may be too high.
SOUND IS MUFFLED
•
Bass too high
•
Treble too low
FEEDBACK: A LOUD SQUEALING, SHRILL
OR HOWLING SOUND THAT IS SELF
GENERATED
•
Feedback occurs when a microphone is
too close to the speaker or the
microphone volume is too high, or the
microphone is pointed towards the
speaker. It is also caused by sound
reflecting off hard surfaces.
•
Reduce or eliminate Feedback by
- Pointing the microphone in a different
direction.
- Keeping the microphone BEHIND the
speakers.
- Turn down the volume levels.
S1995 Outdoor Protective Cover.
Protect your speaker from the elements with the S1995 Outdoor Protective
Cover. Designed for temporary outdoor use, the S1995 Cover is perfect so-
lution for keeping the PA speaker going no matter what the weather dishes
out. This custom-fit cover is made from water-repellant nylon fabric and
sound transparent mesh. Rear access panels let you hook up cables and
access controls with ease while keeping your gear dry.
Two large pockets; 12" L x 8" W x 1 1/2" D with a hook and loop fastener
flap for microphone and cable storage.
MSRP $199.00
Sound transparent mesh
S2045 - Electret Headset Microphone Upgrade
Cardioid pickup pattern and smooth frequency response helps reduce feed-
back problems. Lightweight and adjustable behind the head and over the
ears design will not interfere with hairstyles. Flexible PVC coated gooseneck
microphone boom arm is easily adjustable. (3.5mm/ 1/8" Plug)
MSRP $226.00
MICROPHONE SIGNAL IS WEAK
•
If microphone has batteries, check batteries.
•
Turn on phantom power if applicable.
•
Check cables/connectors.
POWER IS ON, BUT NO SOUND
•
Check volume levels for each channel and
main volume.
•
If using wireless, be sure receiver(s) and/or
transmitter battery is installed and/or is on.
•
If using "line insert", loop must be completed.
WIRELESS MIC DOES NOT WORK
•
Check transmitter battery is alkaline and
ensure transmitter is on.
•
Does yellow "signal" LED light when trans-
mitter is turned on?
•
Are the transmitter and receiver on the same
channel?
WIRELESS MIC CUTS IN AND OUT
•
Is unit visible (line of sight) from user? If not,
move unit into view when using wireless mi-
crophone.
•
Does the yellow "signal" LED go out when
signal drops out? Check battery in transmit-
ter.
SW800-96 MAKES BUZZING NOISE
•
Check cables – a damaged cable will cause
this. Unplug cables one at a time until buzz-
ing stops.
•
Check for Ground loops – use a ground loop
isolator where needed. Will not operate un-
less plugged into AC).
10
BATTERIES WILL NOT HOLD CHARGE
•
Replace Batteries every 1-2 years.
•
A full charge is best obtained when
the unit is off and plugged into the
AC outlet for several hours. After a
year or two the battery may need to
be replaced. Batteries are available
from Amplivox.
•
To replace the batteries use a Phil-
lips screwdriver and take out the 7
screws from the battery cover on the
control panel. Remove the foam
spacer, set aside. Pull out the batter-
ies to access the terminals.
•
Carefully hold the battery with one
hand while you remove the mating
connector. Replace with new battery
and push mating connector of battery
wire onto the corresponding color/
polarity. RED = POSITIVE, BLACK =
NEGATIVE.
•
Place the batteries back in the com-
partment. Replace the foam and
screw on the cover.
NEED HELP? Call 800-267-5486